Extron electronics DTP CrossPoint 84 Setup Manual page 17

DTP I/O Ports, Expansion Port, and LAN Ports
Pins:
12345678
Pin
1
2
3
4
5
6
7
8
Insert Twisted
Pair Wires
RJ-45
A cable that is wired the same at both ends is
called a "straight-through" cable, because
Connector
no pin/pair assignments are swapped.
Figure 7. RJ-45 Connector and Pinout Tables
NOTES:
•
Do not use standard telephone cables. Telephone
Ethernet.
•
Do not stretch or
LAN ports
The LAN ports require Category (CAT) 3, CAT 5e, or CAT 6a unshielded twisted pair (UTP)
or shielded twisted pair (STP) cables, crossover or patch cables.
The cable used depends on your network speed. The switcher LAN port supports both 10
Mbps (10Base-T — Ethernet) and 100 Mbps (100Base-T — Fast Ethernet), half-duplex and
full-duplex Ethernet connections. Input and output boards support 100Base-T only.
• 10Base-T Ethernet requires CAT 3 UTP or STP cable at minimum.
• 100Base-T Fast Ethernet requires CAT 5e UTP or STP cable at minimum.
For ports on an IPCP module, see the
make all network connections and to configure and operate the IPCP control processor.
DTP and Expansion ports
The DTP input and output ports are compatible with Extron XTP DTP 24 SF/UTP cables, as
well as CAT 5e, 6, 6a, and 7 shielded twisted pair (F/UTP, SF/UTP, and S/FTP) cable. The
Expansion port requires CAT 5e, 6, 6a, or 7 shielded twisted pair cable.
For the Expansion port only —
ATTENTION:
•
Connect this port to the Expansion port on a compatible Extron DMP processor. Do NOT connect
this port to a LAN or Power over Ethernet port; equipment damage can occur.
• Connectez ce port au port d'expansion sur un processeur DMP d'Extron
compatible. Ne connectez
Ethernet ; le matériel pourrait être endommagé.
DTP CrossPoint 84 • Installation
Straight-through Cable
End 1 End 2
Wire color Wire color
White-orange White-orange
Orange Orange
White-green White-green
Blue Blue
White-blue White-blue
Green Green
White-brown White-brown
Brown Brown
T568B T568B
bend cables. Transmission errors can occur.
IPCP Pro Series User Guide
ce port à un port LAN ou d'alimentation via
PAS
Crossover Cable
LAN Ports
End 1 End 2
Pin Wire color Wire color
1 White-green White-orange
2 Green Orange
3 White-orange White-green
4 Blue Blue
5 White-blue White-blue
6 Orange Green
7 White-brown White-brown
8 Brown Brown
T568A T568B
A cable that is wired as T568A at one end
and T568B at the other (Tx and Rx pairs
reversed) is a "crossover" cable.
cables do not support Ethernet or Fast
at www.extron.com to
9