Safety
1.6
Allowed Fluids
When measuring fluids, the following points must be observed:
•
Fluids may only be used if, based on state-of-the-art technology or the operating experience
of the user, it is assured that chemical and physical properties of the components coming
into contact with the fluids (signal electrodes, ground electrodes, liners and, possibly,
process connections, protective plates or protective flanges) are not affected during the
operating life.
•
Fluids with unknown properties or abrasive fluids may only be used if the operator can
perform regular and suitable tests to ensure the safe condition of the device.
•
Observe the information on the name plate.
1.7
Operator liability
Before the use of corrosive and abrasive measuring fluid, the operator must clarify the
resistance of all parts that come into contact with the fluid to be measured. ABB will gladly
support you with the selection, however, cannot accept any liability.
The operators must strictly observe the applicable national regulations in their countries with
regards to installation, function tests, repairs, and maintenance of electrical devices.
1.8
Personnel qualification
The installation, commissioning and maintenance of the device may only be carried out through
trained specialist personell authorized by the plant operator. The specialist personnel must have
read and understood the manual and comply with its instructions.
1.9
Transport safety information
Observe the following information:
•
Depending on the device, the center of gravity may not be in the center of the equipment.
The protective plates or dust caps mounted at the process connections of devices equipped
•
with PTFE/PFA may only be removed before installation.
To prevent possible leakage, make sure that the liner on the flange is not cut or damaged.
6 - EN
ProcessMaster / HygienicMaster
CI/FEP300/FEH300-EN