Calibration Function; Activate The Password - ProLights ARCLED3144RGBWA User Manual

18

3.15 CALIBRATION FUNCTION

WHITE SETTING
Enter the [CALIB1] mode to select white color of different color temperature;
• Press the button MENU so many times until show [CALIB1] and press the button ENTER to confirm.
• There are 11 pre-programmed white colors (WHITE01 - WHITE11) can be edited by using red, green,
blue, white and amber (Red - Green - Blue - White - Amber).
• Set the value (000 - 255), through the buttons UP and DOWN.
RGBW TO WHITE SETTING
Enter the [CALIB2] mode to adjust the RGB parameter to make different whites.
• Press the button MENU so many times until show [CALIB2] and press the button ENTER to confirm.
• Select red, green blue or white (RED - GREEN -BLUE), through the button UP/DOWN. Press the but-
ton ENTER to confirm.
• Set the value 000 - 255, through the button UP/DOWN.
• When the new setting is activated, the DMX controller choose RGB=255, 255, 255 the write color will
be made by actual RGB values on the [CALIB2].
3.16 FAN SETTING
To set the speed of the fans:
• Press the button MENU so many time until show [FANS] and press the button ENTER to confirm.
• Select the fan speed mode through the button UP/DOWN (OFF - LOW - NORMAL - HIGH - AUTO).
When fan setting is on [AUTO] mode, the fixture will automatic adjust the fan speed and fixture power,
ensure the fixture temperature is not exceed the limit.
When fan setting is on other modes, the fan will run according to the set speed.

3.17 ACTIVATE THE PASSWORD

Enter the [KEYLOCK] mode to select whether the access password is on or off.
• Press the button MENU so many times until show [KEYLOCK] and press the button ENTER to confirm.
• Select [ON] or [OFF].
Note. The factory access password is UP + DOWN + UP + DOWN. Press ENTER to confirm the access.
ARCLED3144RGBWA