Table of Contents
Advertisement
Accessories
Product Description
The MC600 mower is designed for the sole purpose of fi nish mowing. The MC600 features a 60 inch (152
cm) cutting width and sixteen cutting positions ranging from 3/4 inch (1.9 cm) to 4-1/2 inches (11.4 cm).
The rear discharge design makes it easier to mow up against obstacles without worrying about a discharge
chute getting in the way while protecting mulch beds, buildings, and vehicles from discharged grass and
other debris.
The MC600 can be tilted to a near vertical position for maintenance and storage.
The MC600 features a full width rear roller for even cutting and striping.
Why Do I Need an Operator's Manual?
This manual has been created to help you gain the important knowledge of what is needed to safely oper-
ate, maintain, and service your machine. It is divided into sections for convenient reference of the appropri-
ate section.
You must read and understand the operator's manual for each piece of Ventrac equipment you own. Read-
ing the operator's manual will help you become familiar with each specifi c piece of equipment. Under-
standing the operator's manual will help you, as well as others, avoid personal injury and/or damage to the
equipment. Keep this manual with the machine at all times. The manual should remain with the machine
even if it is sold. If this manual becomes damaged or unreadable, it should be replaced immediately. Con-
tact your local Ventrac dealer for a replacement.
When using a Ventrac attachment, be sure to read and follow the safety and operating instructions of both
the power unit and the attachment being used to ensure the safest operation possible.
The information in this manual provides the operator with the safest procedures to operate the machine
while getting the maximum performance from the unit. Failure to follow the safety precautions listed in this
manual may result in personal injury and/or damage to the equipment.
INTRODUCTION
INTRODUCTION
V
enture Products Inc. is pleased to provide you with your new
Ventrac rear discharge mower! We hope that Ventrac equip-
ment will provide you with a ONE Tractor Solution.
Listed below are just some of the items that can provide you
versatility as you use your MC600 mower. Please visit our web
site, or contact your authorized Ventrac dealer for a complete
list of items available for your new MC600 mower.
Item Description
MC600 Mulching Kit
High Lift Mower Blades
Flat Free Tire/Wheel Assembly (requires 2 per mower)
Introduction - 5
ber
Part Num
70.8088
79.0082
53.0148
Advertisement
Table of Contents
