Table of Contents
Advertisement
Cutting Height Adjustment
Always set the parking brake, shut off the power
unit engine, remove the ignition key, and ensure
all moving parts have stopped before checking
mower deck or blade condition, or attempting
any repair or adjustment.
1.
Lift the height adjustment handle upward and
slide the handle toward the front of the deck to
engage the handle pin (A) into the notch in the
height adjustment lift rocker (B).
2.
Lift the height adjustment
handle slightly and remove the
height adjustment locking pin.
3.
Raise or lower the handle
to the desired cutting height
and replace the height
adjustment locking pin.
4.
Slide the height adjustment
handle towards the rear of the
deck until it is free of the height
adjustment lift rocker and then
rotate down to lay flat along
the carrier frame.
Mulching Kit #70.8088
(Optional Accessory)
Mulching procedures may vary greatly due to cli-
mate, type of grass, and soil conditions. It is gener-
ally best to mow frequently and in dry conditions.
Leaves are usually mulched and dispersed better
when some grass is cut with the leaves.
Mulching often requires more power than normal
mowing. When mulching wet and/or thick grass,
more frequent cleaning of the underside of the deck
may be necessary.
Mulching blades are recommended for mulching.
High lift blades are not recommended. Blades must
be sharp and in good condition for best results.
GENERAL OPERATION
Inset view is shown
A
A
from right side of
deck.
B
B
Operation - 17
Advertisement
Table of Contents
