Install The Controller Unit Of An Slite Tile; Remove The Power Distribution Unit Of An Slite Tile - Barco SLite Service Manual

7. SLite servicing procedures
Image 7-19

7.10 Install the controller unit of an SLite tile

Necessary tools
Nut driver 7 mm
How to install the controller unit of an SLite tile ?
1. Line up the fixation holes of the controller unit with threaded mounting holes on the SMPS frame.
2. Fasten the controller unit with 5 M4 nuts, using a 7 mm nut driver.
3. Plug in the power and data cables on the controller unit. See "Internal wiring diagram", page 7.

7.11 Remove the power distribution unit of an SLite tile

Necessary tools
• Nut driver 7 mm
• Torx driver T20
How to remove the power distribution unit of an SLite tile ?
1. Unplug all wire units on the power distribution unit.
2. Remove the SMPS cover by releasing four M4 nuts using a 7 mm nut driver.
38 R5976621 SLITE DISPLAY 02/09/2005