Barco SLite Service Manual page 26

5. On Screen Display messages
OSD Description
message
Displaying calibration status: Both corrections, luma (white balance) and color (RGB), are enabled. The color
CALI
corrections are calculated with individual LED (pixel) measurements.
FULL
Calibration status can be displayed on request via the XLite toolset.
INDIV
BASED
Displaying frame counter (S0008275) of LED assembly (3).
FRAME
The frame counter can be displayed on request via the XLite toolset per LED assembly.
CNT 3
S000
8275
One or more fans (internal or external) are failing. This message is displayed for a time period of 3 seconds
!!!!
and repeated every 25 seconds.
FAN
Service intervention is required. Ignoring this message will result in more parts of the tile being permanent
FAIL
damaged.
Firmware front-FPGA update message.
FRONT
25%
Firmware back-FPGA update message.
BACK
25%
Message indicating that the software or firmware update is successfully.
DONE
Message indicating that the software or firmware update is failed.
ERROR
Wrong file selected in the XLite toolset for software or firmware update.
WRONG
FILE
Checksum-error in software or firmware update.
CHECK
SUM
ERROR
Calibration starts.
START
CALI
Calibration is done successfully.
CALI
DONE
Calculated calibration corrections are being saved.
SAVE
CALI
The LED board and LED driver have the same frame counter.
BOARD
The LED board–driver match can be displayed on request via the XLite toolset
MATCH
Different frame counters detected between the LED driver and LED board for the following LED assemblies
BOARD
(in this case LED assembly 1, 3 and 6).
SWAP
The LED board–driver match can be displayed on request via the XLite toolset
1-3-6
No frame counter found in some LED drivers or LED boards for the following LED assemblies (in this case
FRAME
LED assembly 4 and 5). Calibration measurements probably not existing.
EMPTY
The LED board–driver match can be displayed on request via the XLite toolset
4-5
I 2 C error occurred while reading frame counter of LED assembly 3.
FRAME
CNT 3
I2C-
ERROR
22 R5976621 SLITE DISPLAY 02/09/2005