6. Place the back cover into position and fasten with 14 bolts, using a 13 mm nut driver.
7.5 Remove the SMPS assembly of an SLite tile
Necessary tools
Nut driver 7 mm
How to remove the SMPS assembly of an SLite tile ?
1. Unplug the six black wire units on the LED-drivers. Do not unplug the connections on the power distribution unit.
Note: The black wire units are attached to the SMPS assembly with cable binders.
2. Unplug the two flat cables between the controller unite and the two lowest LED-drivers..
3. Release the four M4 bolts which attach the SMPS assembly to the frame.
Image 7-8
4. Remove the complete SMPS assembly as illustrated.
Image 7-9
R5976621 SLITE DISPLAY 02/09/2005
7. SLite servicing procedures
33