Table of Contents
Advertisement
Image 7-4
Nuts to release for removing the back cover.
3. Remove the back cover about 40 cm, away from the tile, in horizontal direction.
Caution:
Do not lower down the back cover yet, otherwise the full load of the back cover will damage the power and data
cables and sockets between the tile and the back cover.
Tip:
Let the back cover rest on your chest and one arm.
Image 7-5
Release of back cover.
4. Disconnect the power and data cables between the tile and the re-sync unit.
A
B
Image 7-6
Cables to disconnect between back cover and tile.
A
Flat cable between re-sync unit and controller.
B
Power connection.
C
Wire unit from external fan.
D
Belt.
5. Disconnect the wire unit between the external fan and the power distribution unit.
R5976621 SLITE DISPLAY 02/09/2005
C
D
7. SLite servicing procedures
31
Advertisement
Table of Contents
