Barco SLite Service Manual page 43

7. SLite servicing procedures
Image 7-20
3. Remove the two M4 nuts at the left side of the power distribution unit, using a 7 mm nut driver.
Image 7-21
4. Remove the screw nearby the board to board connector at the right side of the power distribution unit, using a T20 torx driver.
5. Push the right side of the power distribution unit downwards until the board to board connector is unplugged.
1
2
Image 7-22
6. Remove the power distribution unit.
R5976621 SLITE DISPLAY 02/09/2005 39