Table of Contents
Advertisement
3. Connect a safety cable with safety hooks between the eyelid on the LED driver and the eyelid attached inside the frame of the
SLite tile.
Note: This safety cable is required in case of on side servicing to prevent a LED assembly falls down.
Image 7-11
Safety cable.
Image 7-13
4. Release the 14 nuts which attach the LED assembly with the SLite frame, using a 3 mm ballpoint Allen key.
Note: Some of the nuts are located at the tile outside.
Tip:
Barco provides an SLite tooling kit which contains an adapted ballpoint Allen key for LED assembly replacement. This
tool can be very handsome in case of on site servicing.
Image 7-14
R5976621 SLITE DISPLAY 02/09/2005
Image 7-12
Safety hook.
7. SLite servicing procedures
35
Advertisement
Table of Contents
