Dräger X-am 2800 Technical Manual page 31

a. Place the special tool on the trough. Using the special tool, carefully lift out
b. Only if necessary: Exchange the white sensor holder.
c. Have the sensor type and code (marked on the new sensor) as well as the
d. Carefully insert the new sensor evenly and not at an angle. Make sure that
6. Replace the CatEx sensor:
NOTICE
Damage to the flexstrip
If the flexstrip is excessively bent or twisted, it may become irreparably
damaged.
► Do not allow the flexstrip to become excessively bent or twisted.
a. Open the sensor damper.
b. Carefully release the flexstrip from the printed circuit board and remove the
c. Have the sensor type and code (marked on the new sensor) as well as the
|
Technical manual
X-am
the EC sensor in question. Do not bend the sensor pins.
sensor position at hand for the new sensor inauguration.
the pins are inserted in the correct positions.
sensor using a blunt object.
sensor position at hand for the new sensor inauguration.
®
2800
A
Maintenance
B
31