Table of Contents
Advertisement
4-50 Compaq Professional Workstation SP750 Maintenance and Service Guide
Processor Cage
To remove the processor cage:
1. Perform the steps in the "Service Preparations" section in this chapter, then place the
workstation on its side.
2. Remove the following components:
Y
Side access panel
Y
Processor
3. Unscrew the processor cage from the chassis.
4. Remove the processor cage.
Figure 4-45. Unscrewing the four processor cage screws and removing the processor
To replace the processor cage, reverse the above procedure.
CAUTION: Before removing the side access panel, ensure that the workstation is turned off, all
cables are disconnected from the back of the workstation, and the power cord is disconnected
from the grounded AC outlet.
Advertisement
Table of Contents
