Power Supply Air Baffle
To remove the power supply air baffle:
1. Perform the steps in the "Service Preparations" section in this chapter, then place the
workstation on its side.
2. Remove the following components:
Y
Workstation feet
Y
Side access panel
3. Remove the power supply air baffle from the Velcro adhesive tabs.
Figure 4-7. Removing the power supply air baffle
To replace the power supply air baffle, reverse the above procedure.
CAUTION: Before removing the side access panel, ensure that the workstation is turned off, all
cables are disconnected from the back of the workstation, and the power cord is disconnected
from the grounded AC outlet.
Removal and Replacement Procedures 4-9