Removing a Hard Drive from Bays 5 or 6
Drive bays 5 and 6 can be configured with either a 1.0-inch or 1.6-inch hard drive. To remove a
hard drive:
NOTE: Before removing a SCSI device, please read the "SCSI Guidelines" chapter in the Compaq Service
Reference Guide .
1. Turn off the workstation and disconnect the power cord from the grounded AC outlet and
the back of the workstation.
2. Remove the following components:
Y
Side access panel
Y
Front bezel
3. Refer to the following illustrations to remove a hard drive from bays 5 or 6.
Figure 4-14. Disconnecting the SCSI signal cable and power cable
CAUTION: Before removing the side access panel, ensure that the workstation is turned off, all
cables are disconnected from the back of the workstation, and the power cord is disconnected
from the grounded AC outlet.
Removal and Replacement Procedures 4-17