Table of Contents
Advertisement
Blank Drive Bezel
To remove the blank drive bezel from the front bezel:
1. Perform the steps in the "Service Preparations" section in this chapter, then place the
workstation on its side.
2. Remove the following components:
Y
Side access panel
Y
Front bezel
3. Remove the screws that secure the blank drive bezel, then remove the blank bezel from
the front bezel.
Figure 4-5. Removing the blank bezel
To replace the blank drive bezel, reverse the above procedure.
CAUTION: Before removing the side access panel, ensure that the workstation is turned off, all
cables are disconnected from the back of the workstation, and the power cord is disconnected
from the grounded AC outlet.
Removal and Replacement Procedures 4-7
Advertisement
Table of Contents
