The Paper Is Too Small - Canon imagePROGRAF iPF765 Basic Manual

iPF765
Cause
When Detect Mismatch in the Control Panel menu is
set to Pause or Hold Job, paper smaller than the size
specified in the printer driver is loaded.
When Detect Mismatch in the Control Panel menu is
set to Warning, paper smaller than the size specified
in the printer driver is loaded.

The paper is too small.

The paper is too small.
"Replace paper with A4/LTR (vertical) or larger"
Cause
The loaded paper is too small.
"Replace roll with 10 in. wide or larger roll."
Cause
The loaded paper is too small.
Basic Guide
However, note that this error may cause paper jams and affect the printing quali-
ty.
Adjust the paper size setting in the printer driver to match the size loaded in the
printer as follows.
1.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
2.
Change the paper size setting in the printer driver to the size loaded in the
printer and try printing again.
Replace the loaded paper with paper of a size that matches the size setting in
the printer driver as follows.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button to stop
printing.
2.
Replace the loaded paper to match the paper width setting in the printer driver
and try printing again.
You can continue to print, but note that this error may cause problems in the
printing results.
Replace the paper with paper of A4/Letter (vertical) size or larger as follows.
1.
Press ▲ or ▼ to select Change Paper, press the OK button, and remove the paper.
(See "Removing Sheets.") →P.20
2.
Switch to paper A4/Letter (vertical) or larger.
(See "unknown.")
→User's Guide
The printer will resume printing.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Corrective Action
Replace the roll with a roll 10 inches in width or larger as follows.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.")
(See "Removing the Roll Holder from Rolls.")
2.
Replace the roll with a roll 10 inches wide or larger.
(See "Attaching the Roll Holder to Rolls.")
(See "Loading Rolls in the Printer.")
The printer will resume printing.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Corrective Action
Corrective Action
→P.15
→User's Guide
→P.9
→P.12
The paper is too small.
111