iPF765
Cause
During cutting, printed documents fall out at an
angle.
Paper is not cut
Paper is not cut
In the printer driver, No or Print Cut Guideline is specified in Auto
Cut.
In the Control Panel menu, Cutting Mode is set to Eject or Manual.
Depression on the leading edge is left
Depression on the leading edge is left
Cause
Keeping a roll in the printer for a long time with-
out printing on it may leave a depression on the
leading edge.
The size of clear film cannot be detected
The size of clear film cannot be detected
Cause
The Platen is soiled with ink or other substances.
Roll Paper is Continuously Ejected
Roll Paper is Continuously Ejected
Cause
Although sheets are se-
After roll ejection stops, follow these steps to reload the roll.
lected as the paper
1.
source, a roll was ad-
2.
vanced.
3.
4.
5.
Basic Guide
In the Control Panel menu, set Cutting Mode to Eject. Hold documents after print-
ing, as they are cut.
(See "Specifying the Cutting Method for Rolls.")
Cause
When printing quality is most important, we recommend setting TrimEdge Reload to
On or Automatic so that the paper edge is automatically cut before printing.
(See "Menu Structure.")
Open the Top Cover and clean the entire Platen.
(See "Cleaning Inside the Top Cover.")
Push the Release Lever back.
Open the Roll Cover.
Using both hands, rotate the Roll Holder toward the back to rewind the roll. At this time, ensure that both
ends of the roll are rewound evenly.
Pull the Release Lever forward.
Load the roll. At this time, be sure to press the Load button and select Load Roll Paper.
(See "Loading Rolls in the Printer.")
Corrective Action
→User's Guide
Corrective Action
Specify Yes in Auto Cut in the printer driver.
If the Cutting Mode is Eject, press the Cut button to cut the paper.
If the Cutting Mode is Manual, cut rolls with scissors or the like.
Corrective Action
→P.48
Corrective Action
→P.39
Corrective Action
→P.12
Paper is not cut
91
Need help?
Do you have a question about the imagePROGRAF iPF765 and is the answer not in the manual?