Prepare For Parts Replacement; Parts Replacement Time Has Passed; Unknown File; Error In Cutter Position - Canon imagePROGRAF iPF765 Basic Manual

Prepare for parts replacement.

Prepare for parts replacement. Prepare for parts replacement.
Cause
It is almost time to replace consumables for
which service is required.

Parts replacement time has passed.

Parts replacement time has passed.
It is past the recommended time to replace consumables for which service is required.

Unknown file.

Unknown file.
Data sent to keep the printer up to date (such as paper
information) is in the wrong format.
You have uploaded firmware for a different model.

Multi-sensor error

Multi-sensor error
Direct sunlight or strong lighting may be shining on the
printer and causing the sensor to malfunction.
The performance of a sensor inside the printer may be
impaired.

Error in cutter position.

Error in cutter position.
Cause
The Cutter Unit stops in the middle of cutting.
128
You can continue to use the printer for some time until "Parts replacement time has
passed." will be displayed.
Contact your Canon dealer for assistance.
Cause
Cause
Check the data. Turn off the printer and wait a while before restoring power, and
then resend the data.
Check the firmware version. Turn off the printer and wait a while before restor-
ing power, and then resend the firmware.
If the message is displayed again, contact your Canon dealer for assistance.
Cause
Take steps to ensure the printer is not used when exposed to direct sunlight or
strong lighting.
Turn off the printer and wait at least three seconds before restoring the power.
If the message is displayed again, contact your Canon dealer for assistance.
1.
Push the Release Lever back and remove the paper.
2.
Pull the Release Lever forward.
Corrective Action
Corrective Action
Contact your Canon dealer for assistance.
Corrective Action
Corrective Action
Corrective Action
iPF765
Basic Guide