Table of Contents
Advertisement
Output Wires No Conductor Pretreatment: All kinds of copper conductors can be clamped
without pretreatment (Solid, Flexible, with ferrule, with/without plastic sleeve). It is forbidden to solder
the conductors. The solder tin yields and fractures under high pressure. The result is an increased
contact resistance and an excessive temperature rise. In addition, corrosion caused by pickling or
fluxes has been observed on soldered conductor ends. Notch fractures at the transition point from
the rigid to the flexible conductor area are also possible.
Ausgangsleitungen Keine Leitervorbehandlung: Alle Arten von Kupferleitungen können ohne
Vorbehandlung fest geklemmt werden (feste, flexible, mit Aderendhülse, mit/ohne Kunststoffhülse).
Es ist verboten, die Leiter zu löten. Das Lötzinn gibt unter Druck nach und bricht. Dies führt zu
einem erhöhten Kontaktwiderstand und einem übermäßigen Temperaturanstieg. Zusätzlich wurde
auf gelöteten Leiterenden von Beiz- oder Flussmitteln verursachter Rost beobachtet. Kerbenbrüche
am Übergangspunkt vom starren zum flexiblen Leiterbereich sind ebenfalls möglich.
The 150V to 600V models have four terminal wire clamp output connector. The two left terminals are
positive outputs and the other two right terminals are the negative outputs.
The connector requirements are as follows:
•
Connector type: GIC 2.5/ 4-G-7,62 (Phoenix Contact).
Plug type: GIC 2.5/ 4-ST-7,62 (Phoenix Contact).
•
•
Wires: AWG12 to AWG24, according to Table 4-2.
Follow the instructions below for connection of the load wires to the power supply:
1. Refer to Table 4-2 for the recommended load wires. Strip approx. 10mm at the end of each wire.
2. Loosen the mating connector terminal screws.
3. Insert the stripped wires into the terminals and tighten the terminal screws securely (see Figure
4-22). Tightening torque: 4.4-5.3 Lbf-inch. (0.5-0.6Nm).
4. Tighten the mating connector to the power supply rear panel (see Figure 4-22). Tightening torque:
6.2-7 Lbf-inch. (0.7-0.8Nm).
Mating connector
GIC 2.5/4-ST-7.62
Figure 4-22: Four Wires Connection to The Output Plug
CAUTION
VORSICHT
57
Tightening torque:
4.4-5.3 Lbf-inch.
0.5-0.6Nm
Advertisement
Table of Contents
