Table of Contents
Advertisement
For 20V - 100V models:
4. Fix the wires to the Bus bars as shown in
Spring Washer
M6 screw
For 10V - 100V models:
3. Fix the Bus bar cover to the rear panel of the power supply using M3X40 Sems screw from the
accessories kit, as shown in Figure 4-21.
Figure 4-21: Fixing Bus bars cover to the rear panel
For 150V to 600V models:
There is a potential shock hazard when using a power supply with an output voltage greater than
60VDC. Do not turn ON power supply without output plug protection assembled. Ensure that the
protection of output plug is mounted and properly assembled.
Bei Einsatz eines Netzgeräts mit mehr als 60VDC Nennspannung besteht das Risiko eines
Stromschlags. Schalten Sie kein Netzgerät, wenn die Schutzabdeckung des Ausgangssteckers
nicht installiert ist.
Flat Washer
Figure 4-20: 20V-100V Wires Assembly
WARNING
WARNUNG
56
M6 Hex. Nut
Tightening Torque:
36.3-48.7lbf-in
4.1-5.5Nm
Washer
M3X40 Tightening Torque:
4.7-5.8lbf-in
0.53-0.65Nm
Advertisement
Table of Contents
