Canon VB-M40 Operation Manual page 61

• Audio Reception
• Output Volume
Caution
Switch line in and microphone in on each setting page
according to the specification of the microphone
(P. 5-18).
Using the wrong input may damage the camera and/or
microphone. Be sure to configure settings correctly.
Important
The volume, sound quality, etc., may change depending on the
characteristics of the microphone used.
• If [Input Volume] or [Echo Canceller] settings are changed after
setting volume detection, check the detection setting again.
• RM Viewer is needed to when setting [Audio Reception from
Viewer] to [Enable]. No sound will be output from the camera
when using this function with VB-M700/600/40 Viewer since
the viewer does not support transmitting sound.(P. 1-6)
• Connect a speaker with amplifier to the camera ("Audio
Input/Output Terminals" in the "Installation Guide").
• If [Enable] is selected under [Echo Canceller], the sound
quality or volume may be affected. Utilize this function as
necessary according to the installation environment and how
the camera is used.
• When sending audio, carefully read the information in
"Important" under "Audio Input/Output Terminals" in the
"Installation Guide."
HTTP Server
1 [Authentication Method]
Set the authentication method used with the HTTP
server to [Basic Authentication] or [Digest
Authentication].
2 [HTTP Port]
Set the HTTP port number to 80 or in the range of 1024
to 65535.
Normally [80] (factory default setting) is used.
3 [HTTPS Port]
[Server] Setting the Image Server, Audio Server and HTTP Server
Set the HTTPS port number to 443 or in the range of
1024 to 65535.
Normally [443] (factory default setting) is used.
4 [Global Address for the Web Page]
If a fixed global address is assigned to the camera
using the NAT function of the router, set the global
address and port number here. If [IP Address] is
selected, enter the IP address specified in the [IPv4
Address] field. If [Host Name] is selected, the host
name specified in [DNS] under [Network] will be used.
Set the necessary items under [DNS] (P. 5-6).
Important
• If the setting of [HTTP Port] or [HTTPS Port] is changed, the
camera may become inaccessible from the active web
browser. Check beforehand the precautions in "Important" in
"[Reboot Item] Setting Items Requiring Rebooting" (P. 5-32).
• If [IP Address] is selected under [Global Address for the Web
Page], be sure to set both [IPv4 Address (global address for
the web page)] and [Port Number (global address for the
web page)]. If [Host Name] is selected, also be sure to set
[Host Name] under [DNS] in [Network] on the Setting page.
5
5
-19