Figure 12.20: LFSR test pattern received and histogram containing transmission errors
12.8 Status Line and Image Information
There are camera properties available that give information about the acquired images, such
as integration time, ROI settings or average image value. These properties can be queried by
software. Alternatively, a status line within the image data can be switched on that contains all
the available image information.
12.8.1 Image Average Value
The average image value gives the average of an image in 12 bit format (0 .. 4095 DN),
regardless of the currently used grey level resolution. Note that the 12-bit format was chosen
to be compatible with other Photonfocus cameras
12.8.2 Status Line Format
If enabled, the status line replaces the last row of the image with camera status information.
Every parameter is coded into fields of 4 pixels (LSB first) and uses the lower 8 bits of the pixel
value, so that the total size of a parameter field is 32 bit (see Fig. 12.21). The assignment of the
parameters to the fields is listed in Table 12.4.
The status line is available in all camera modes.
M S B
L S B
P i x e l :
0
1
2
3
F F
0 0
B B
6 6
P r e a m b l e
Figure 12.21: Status line parameters replace the last row of the image
.
MAN093 08/2021 V1.1
M S B
L S B
L S B
"
5
6
7
8
9
1 0
F i e l d 0
F i e l d 1
12.8 Status Line and Image Information
M S B
M S B
L S B
L S B
1 1
1 2
1 3
1 4
1 5
1 6
1 7
F i e l d 2
F i e l d 3
M S B
M S B
L S B
1 8
1 9
2 0
2 1
2 2
2 3
F i e l d 4
87 of 143