To install the equipment, proceed as specified in Tab. 6.33.:
Step
Action
1
Apply the checks in paragraph 6.1.3 ("Checks before installation").
2
Remove any type of packaging/equipment protection (if any).
Connect making sure that:
•
the inlet and outlet pipes do not exert excessive bending or traction forces on the regulator body as a result
of not being aligned. If necessary, clamp the inlet/outlet pipes for proper alignment;
•
the connections and/or terminals of the inlet and outlet pipes are suitable for and compatible with the
fittings on the regulator.
3
NOTE!
•
If there are swivel connectors, use the gaskets supplied by PIETRO FIORENTINI S.p.A.
•
In case of direct assembly in the regulator body, use only cylindrical GAS connections (ref.
UNI EN ISO 228-1).
NOTE!
The warranty shall be deemed null and void and PIETRO FIORENTINI S.p.A. shall not be held liable for any
damage and/or malfunctions if the fittings used during installation are not those supplied.
6.4.1 - POST-INSTALLATION INSTRUCTIONS
WARNING!
Make sure all connections are properly tightened to prevent any leakage during commissioning.
WARNING!
Protect the regulator from blows and impacts, even accidental.
LOW-PRESSURE GAS REGULATOR
EN
Use, maintenance and warning manual
|
INSTALLATION
|
REV. 00
Tab. 6.33.
54