Paths - HP c8000 Technical Reference Manual

System Configuration
3. Configure the terminal emulation software with these settings:
Baud rate: 9600
Bits: 8
Parity: None
Stop Bits: 1 (one)
Flow Control: XON/XOFF
4. Using the terminal emulation software, connect to the workstation with a direct connection.
5. Turn on the workstation. The system display is redirected to the serial console device.

Paths

All devices in the HP workstation c8000 are represented by paths in the BCH. To identify the
correct slot or disk drive, use the following tables.
Accessory Card Slots
Slot
1 PCI (33 MHz, 32 bit, half-length)
2 PCI (33 MHz, 32 bit, half-length)
3 AGP 8X 32 bit
4 PCI (33 MHz, 64 bit)
5 PCI-X (66 MHz, 64 bit)
6 PCI-X (66 MHz, 64 bit)
7 PCI-X (133 MHz, 64 bit)
IDE Drives
Drive
IDE hard drive 1 (or optical drive 3) 0/3/2/0.0.0
IDE hard drive 2
IDE optical drive 1
IDE optical drive 2
2–2
Path
0/3/5/0
0/3/4/0
0/4/0/0
0/3/6/0
0/2/2/0
0/2/3/0
0/0/1/0
Path
0/3/2/0.0.1
0/3/2/0.1.0
0/3/2/0.1.1
Hardware Connection
IDE 0, master
IDE 0, slave
IDE 1, master
IDE 1, slave
Technical Reference Guide