Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
Indicator status
Off
Lit
Red
Blinking
Green
Lit
Orange
Lit
Note
f While the power indicator <ON (G)/STANDBY (R)> lights orange, the fan is running to cool the projector.
f For approximately five seconds after the projector is turned off, the indicator does not light up even if the power is turned on. Turn on the
power again after the power indicator <ON (G)/STANDBY (R)> lights/blinks red.
f The projector consumes power even in standby mode (power indicator <ON (G)/STANDBY (R)> lights/blinks red). Refer to "Maximum power
consumption" ( x page 213) for the power consumption.
f The power indicator <ON (G)/STANDBY (R)> will blink if the projector receives a remote control signal.
f The power indicator <ON (G)/STANDBY (R)> will blink green slowly while the shutter function is in use (shutter: closed), or while the function
of the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [POWER MANAGEMENT] → [NO SIGNAL LIGHTS-OUT] is operating
and the light source is turned off.
Switching on the projector
1)
Connect the power cord to the projector.
2)
Connect the power plug to an outlet.
3)
Press the <ON> side of the <MAIN POWER> switch to turn on the power.
f The power indicator <ON (G)/STANDBY (R)> lights/blinks red, and the projector enters the standby mode.
The main power is switched off.
The power is switched off. (standby mode)
Projection will start when the power < v / b > button is pressed.
f The setting of the projector is as follows.
g The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [QUICK STARTUP] is set to [OFF]
g The [PROJECTOR SETUP] menu → [AUDIO SETTING] → [IN STANDBY MODE] is set to [OFF]
f The projector may not operate when the light source indicator <LIGHT> or the temperature indicator
<TEMP> is blinking. ( x page 193)
The power is switched off. (standby mode)
Projection will start when the power < v / b > button is pressed.
f The projector is in one of the following states.
g The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [QUICK STARTUP] is set to [ON]
g The [PROJECTOR SETUP] menu → [AUDIO SETTING] → [IN STANDBY MODE] is set to [ON]
g The output image corresponding to the projected image from the projector is being checked by
the web control function. For details, refer to "[Remote preview lite] page" ( x page 157).
f The indicator will change to a red light when the specified time has elapsed after the projector enters
the standby mode if the projector is set as following. However, the indicator will not change to a red
light while the output image is being checked by the web control function.
The specified time is a time set in the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] →
[QUICK STARTUP] → [VALID PERIOD].
g The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [QUICK STARTUP] is set to [ON]
g The [PROJECTOR SETUP] menu → [AUDIO SETTING] → [IN STANDBY MODE] is set to [OFF]
f The projector may not operate when the light source indicator <LIGHT> or the temperature indicator
<TEMP> is blinking. ( x page 193)
Projecting.
The projector is preparing to switch off the projector.
The power is switched off after a while. (Changes to the standby mode.)
3)
1)
2)
Projector status
4)
4)
ENGLISH - 43
Advertisement
Table of Contents
