Table of Contents
Advertisement
Basic format (has subcommands)
Sub command (5 bytes)
*1 When transmitting a command which does not need a parameter, an operation (E) and parameter are not necessary.
Attention
f If a command is sent after the light source starts lighting, there may be a delay in response or the command may not be executed. Try
sending or receiving any command after 60 seconds.
f When transmitting multiple commands, be sure to wait until 0.5 seconds has elapsed after receiving the response from the projector before
sending the next command. When transmitting a command which does not need a parameter, a colon (:) is not necessary.
Note
f If a command cannot be executed, the "ER401" response is sent from the projector to the computer.
f If an invalid parameter is sent, the "ER402" response is sent from the projector to the computer.
f ID transmission in RS-232C supports ZZ (ALL) and 01 to 64.
f If a command is sent with an ID designated, a response will be sent to the computer only in the following cases.
g It matches the projector ID
g ID is designated as ALL and [RESPONSE(ID ALL)] is set to [ON]
f STX and ETX are character codes. STX shown in hexadecimal is 02, and ETX shown in hexadecimal is 03.
Cable specification
Control command
The following table lists the commands that can be used to control the projector using a computer.
r Projector control command
Command
Details
PON
Power on
POF
Power standby
QPW
Power query
Chapter 7 Appendix — Technical information
Parameter (6 bytes)
Symbol "+" or "–" (1 byte) and setting or adjustment value (5
bytes)
Operation (1 byte)
*1
"=" (Set the value specified using parameter)
When connected to a computer
1
NC NC
2
3
Projector
4
NC NC
(<SERIAL IN> terminal)
5
6
NC NC
7
8
9
NC NC
Parameter/response
string
―
000
001
Same as the basic format
*1
1
2
3
Computer
4
(DTE specifications)
5
6
7
8
9
Remark (parameter)
To check if the power is on, use the "Power query" command.
STANDBY
Power on
ENGLISH - 209
Advertisement
Table of Contents
