Table of Contents
Advertisement
Note
f If the password of the administrator account has not been set, that is, if it is left blank, the network function of this projector cannot be used.
Set a password before using the web control function or the communication control (including operation with application software) via LAN.
[PJLink PASSWORD]
Set the password for security authentication which is required when connecting to the projector.
1)
Press as to select [PJLink].
2)
Press the <ENTER> button.
f The [PJLink] screen is displayed.
3)
Press as to select [PJLink PASSWORD], and press the <ENTER> button.
f The [PJLink PASSWORD] screen is displayed.
4)
Press as to select [PASSWORD] under [CURRENT], and press the <ENTER> button.
f The [PASSWORD] screen is displayed.
5)
Press asqw to select a character, and press the <ENTER> button.
f Enter the current password.
f The factory default setting of password is blank.
6)
After entering the password, press asqw to select [OK], and press the <ENTER> button.
f The [PJLink PASSWORD] screen is displayed.
7)
Press as to select [PASSWORD] under [NEW], and press the <ENTER> button.
f The [PASSWORD] screen is displayed.
8)
Press asqw to select a character, and press the <ENTER> button.
f Enter a new password.
f Up to 32 alphanumeric characters can be entered.
9)
After entering the password, press asqw to select [OK], and press the <ENTER> button.
f The [PJLink PASSWORD] screen is displayed.
10) Press as to select [PASSWORD CONFIRM], and press the <ENTER> button.
f The [PASSWORD CONFIRM] screen is displayed.
11) Enter the password entered in Step 8).
12) After entering the password, press asqw to select [OK], and press the <ENTER> button.
f The [PJLink PASSWORD] screen is displayed.
13) Press as to select [STORE], and press the <ENTER> button.
f The confirmation screen is displayed.
14) Press qw to select [OK], and press the <ENTER> button.
Note
f The PJLink password can also be changed on the "[Set up password] page (for administrator account)" ( x page 176) of the web control
screen.
[PJLink CONTROL]
Set to enable or disable the PJLink protocol control function.
1)
Press as to select [PJLink].
2)
Press the <ENTER> button.
f The [PJLink] screen is displayed.
3)
Press as to select [PJLink CONTROL].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
144 - ENGLISH
Chapter 4 Settings — [NETWORK] menu
Advertisement
Table of Contents
