Table of Contents
Advertisement
8)
Press the <ENTER> button.
f The [VERTICAL SCAN FREQUENCY] screen is displayed.
9)
Press qw to select [VERTICAL SCAN FREQUENCY].
f Select [60Hz], [50Hz], [30Hz], [25Hz], or [24Hz] when [1920x1080p] is selected for [RESOLUTION].
f Select [60Hz], [50Hz], or [48Hz] when [1920x1080i] is selected for [RESOLUTION].
f Select [60Hz] or [50Hz] when anything other than following is selected for [RESOLUTION].
g [1920x1080p], [1920x1080i]
10) Press the <ENTER> button.
f The confirmation screen is displayed.
11) Press qw to select [OK], and press the <ENTER> button.
Note
f The settings in [RESOLUTION] and [VERTICAL SCAN FREQUENCY] are displayed in [EDID STATUS].
f Setting of the resolution and the vertical scanning frequency may be necessary on the computer or video device in use.
f The computer, video device, or projector in use may require the power to be turned off and on again after setting.
f The output with the set resolution or vertical scanning frequency may not be possible depending on the computer or video device in use.
[HDMI1 IN] / [HDMI2 IN]
Set this item in accordance with the image signal input to the <HDMI IN 1> terminal or the <HDMI IN 2> terminal.
Setting [SIGNAL LEVEL] in [HDMI1 IN] or [HDMI2 IN]
1)
Press as to select [HDMI1 IN] or [HDMI2 IN].
2)
Press the <ENTER> button.
f The [HDMI1 IN] screen or the [HDMI2 IN] screen is displayed.
3)
Press as to select [SIGNAL LEVEL].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO]
[64-940]
[0-1023]
Note
f The optimal setting varies depending on the output setting of the connected external device. Refer to the operating instructions of the
external device regarding the output of the external device.
f The HDMI signal level is displayed for 30 bits of input.
Setting [AUTO GAMMA SELECT] in [HDMI1 IN] or [HDMI2 IN]
Set this item when the gamma mode is to be automatically set based on the InfoFrame information added to the
image signal.
1)
Press as to select [HDMI1 IN] or [HDMI2 IN].
2)
Press the <ENTER> button.
f The [HDMI1 IN] screen or the [HDMI2 IN] screen is displayed.
3)
Press as to select [AUTO GAMMA SELECT].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
94 - ENGLISH
Chapter 4 Settings — [DISPLAY OPTION] menu
Automatically sets the signal level.
Select this item when the signal output from the HDMI terminal of the external device (such as a Blu-
ray disc player) is input to the <HDMI IN 1> terminal or the <HDMI IN 2> terminal.
Select this item when the signal output from the DVI-D terminal of the external device (such as a
computer) is input to the <HDMI IN 1> terminal or the <HDMI IN 2> terminal using a conversion cable,
etc.
Select this item also when the signal output from the HDMI terminal of a computer, etc., is input to the
<HDMI IN 1> terminal or the <HDMI IN 2> terminal.
Advertisement
Table of Contents
