Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
Initial setting (standby mode)
Set the operation mode during standby. The factory default setting is [NORMAL], which allows you to use the
network function during standby. To keep power consumption low during standby, set this item to [ECO].
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu → [ECO
MANAGEMENT] → [STANDBY MODE].
1)
Press qw to switch the setting.
2)
Press the <ENTER> button to proceed to the initial setting.
Initial setting (screen setting)
Set the screen format (aspect ratio) and display position of the image.
After completed the initial setting, you can change the settings of each item from the [DISPLAY OPTION] menu →
[SCREEN SETTING].
1)
Press qw to switch the setting.
f The setting will change each time you press the button.
f Proceed to Step 4) when [16:9] is selected.
2)
Press as to select [SCREEN POSITION].
3)
Press qw to adjust.
INITIAL SETTING
STANDBY MODE
NORMAL
When set to ECO,
network functions and some RS-232C commands
are not available during standby.
CHANGE
SET
ENTER
INITIAL SETTING
SCREEN FORMAT
16:9
Set as necessary for the screen in use.
CHANGE
SET
ENTER
INITIAL SETTING
SCREEN FORMAT
16:10
SCREEN POSITION
0
Set as necessary for the screen in use.
MENU SELECT
CHANGE
SET
ENTER
4/7
5/7
5/7
ENGLISH - 47
Advertisement
Table of Contents
