Table of Contents
Advertisement
10) Click [Start].
f Update is started.
f The temperature indicator <TEMP> and the light source indicator <LIGHT> on the projector blink red
alternately while updating.
f Elapsed time and rough progress can be confirmed in the update status display screen. The required time
is approximately 15 minutes.
11) Confirm the completion of the update.
f Once the update is completed, the completion confirmation screen is displayed.
f To continue to update the firmware of another projector, click [Yes]. The connection setting screen in Step 7)
is displayed.
f To end the update tool, click [No].
12) Confirm the firmware version.
f Turn on the power of the projector and confirm the firmware version in the [STATUS] screen.
Attention
f Do not disconnect the main power of the projector or disconnect the LAN cable while updating.
Note
f In following cases, turn the power of the projector off and on and perform the update from the beginning.
g When the update does not complete after 60 minutes or more have elapsed
g When the power of the projector or the computer has turned off due to power outage, etc., during the update
Updating the firmware using the USB memory
Supported device
f Commercially available USB memory is supported.
The USB memory with a security function is not supported.
f Only the cards formatted in FAT16 or FAT32 can be used.
f Only the single partition structure is supported.
Chapter 5 Operations — Updating the firmware
ENGLISH - 189
Advertisement
Table of Contents
