Panasonic PT-FRQ60 Operating Instructions Manual page 163

For wired LAN connection
1 [PROJECTOR NAME]
Enter the name of the projector. Enter the host name if it is
required when using a DHCP server etc.
2 [DHCP ON], [DHCP OFF]
To enable the DHCP client function, set to [DHCP ON].
3 [IP ADDRESS]
Enter the IP address when not using a DHCP server.
4 [SUBNET MASK]
Enter the subnet mask when not using a DHCP server.
5 [DEFAULT GATEWAY]
Enter the default gateway address when not using a DHCP
server.
6 [DNS1]
Enter the DNS1 server address.
Permissible characters for the entry of DNS1 server address
(primary):
Numbers (0 - 9), period (.)
(Example: 192.168.0.253)
Note
f When you use the "Forward" and "Back" functions of your browser, a warning message "Page has Expired" may appear. In that case, click
[Network config] again since the following operation will not be guaranteed.
f Changing LAN settings while connected to the LAN may cause the connection to disconnect.
For wireless LAN connection
(Available only when the Wireless Module is attached to the projector)
1 [KEY]
Sets the connection key.
Enter 8 to 15 characters of single-byte alphanumeric.
Chapter 5 Operations — Using the web control function
1
2
3
4
5
6
7
8
7 [DNS2]
Enter the DNS2 server address.
Available characters for the entry of DNS2 server address
(secondary):
Numbers (0 - 9), period (.)
(Example: 192.168.0.254)
8 [Back], [Next]
Click [Back] to return to the original screen. Click [Next] to display
the setting confirmation screen. Click [Submit] to update the
setting.
2 [Back], [Next]
Click [Back] to return to the original screen. Click [Next] to display
the setting confirmation screen. Click [Submit] to update the
setting.
1
2
ENGLISH - 163