Table of Contents
Advertisement
Mounting e430
Single gang mounting
1. Remove single-gang box cover.
2. Place Cambium single-gang wall bracket on the gang box and secure with at least 2 screws.
3. Connect Ethernet cable to the upper RJ-45 port labelled Eth1/PoE at the rear side of e430 to
provide connectivity. Use the other RJ-45 port labelled Pass-Through for any additional cable that
might need to pass through e430.
4. Align the two slots at rear side of the e430 with two hooks on the bracket.
5. Secure e430 to the bracket with a screw at the bottom edge of e430 using standard Torx security
screw or standard Philips head screw.
Chapter 2: Packaging and Installation of Access Point
44
Advertisement
Table of Contents
