Table of Contents
Advertisement
Mounting e410/e600
The e410/e600 units are mounted by using one of the following mounting techniques:
Ceiling mount,
l
Wall mounting, or
l
T-bar mounting.
l
Ceiling mount
To mount the e410/e600 unit by using the ceiling mount technique, perform the following steps:
1. Determine where the AP needs to be mounted and remove the ceiling tile.
2. Using the hole template, mark the hole locations.
3. Drill the holes for the 4 mounting screws using a 5mm (3/6") diameter drill bit.
4. Drill the RJ45 cable hole using a 15 mm (5/8") diameter bit.
5. Hold the mounting plate on the top side of the ceiling tile and screw it on the mounting bracket.
6. Run the RJ45 cable through the 15mm hole and remount the ceiling tile.
Chapter 2: Packaging and Installation of Access Point
38
Advertisement
Table of Contents
