Installation Procedures For 9300-32D Switches; Installation Precautions And Guidelines - HP aruba 9300-32D Series Installation And Getting Started Manual

If you have not already done so, order an Aruba rack mount kit for use with your switch.
Rack mounting your Aruba 9300-32D switch is supported using these rack mount kits:
JL483C, Aruba Universal 4-Post Rack Mount Kit (Ordered separately)
n
JL448A, Aruba X2C2 RJ45- DB9 Console cable (Ordered separately)
n

Installation Procedures for 9300-32D Switches

1. Prepare the Installation Site on page 24
2. Install Power Supplies on page 25
3. Install Fan Trays on page 25
4. Power-on the switch and check LEDs on page 26
5. Power off the switch on page 26
6. Mount the Switch on page 26
7. Install Transceivers on page 32
8. Connect the Switch to a Power Source on page 33
9. Setup for Initial Configuration on page 34

Installation Precautions and Guidelines

To help avoid personal injury or product damage when installing your switch, read the following installation
precautions and guidelines.
Do not mount the switch on a wall, under a table, or under any other horizontal surface.
n
Mount devices installed in a rack or cabinet as low as possible. Put the heaviest devices at the bottom and
n
progressively lighter devices positioned higher.
To prevent the rack or cabinet from becoming unstable and/or falling over, ensure that it is adequately
n
secured.
The switch may use more than one power supply cable. To fully power down the switch, you must
n
disconnect all power supply cables from the switch.
(optional)
Installing the switch | 23