Output The Sine Waveform - Owon HDS272S User Manual

is 50Ω).
Note: To change the load value, after selecting *Ω, press
direction
/
key to move the cursor left and right; press direction key to change
/
the value. The load range is 1 Ω - 10 kΩ.

Output the sine waveform

The sine waveform setting menu includes: Frequency/Period, Amplitude/High
Level, Offset/Low Level.
Set the Frequency / Period
Press the F1 key to enter the sine waveform setting interface.
Press the F3 or F4 key to switch to the Frequency/Period parameter,
the selected parameter item will be displayed in green (the same below), and
then use the direction keys to set the desired value in the
parameter column. Press F2 to switch between Frequency / Period.
Use the direction keys to change the selected parameter
value:
Press to increase or decrease the value at the cursor. Press to
/ /
move the cursor left and right to different numerical digits.
Note: When setting parameters, long press the key to accelerate the
change of the value.
Set the Amplitude / High Level
Press the F3 or F4 key to switch to the Amplitude/High Level
parameter, and then use the direction keys to set the desired
value in the parameter column. Press F2 to switch between Amplitude /
High Level.
Set the Offset / Low Level
Press the F3 or F4 key to switch to the Offset/Low Level parameter,
and then use the direction keys to set the desired value in the
parameter column. Press F2 to switch between Offset / Low Level.
27