Interfunction Delay - Honeywell YOUJIE YJ-HH360 User Manual

Next, scan the Character to Trigger Delay bar code, then the 2-digit hex value
for a printable character to trigger the delay (see
on page A-5). The range is 00-FF.
Delay Length
To remove this delay, scan the Delay Length bar code, and set the number of
steps to 0. Scan the Save bar code using the
back cover of this manual.

Interfunction Delay

An interfunction delay of up to 495 milliseconds may be placed between the
transmission of each control character in the message string. Scan the Inter-
function Delay bar code below, then scan the number of steps in 5 millisecond
increments and the Save bar code using the
back cover of this manual.
To remove this delay, scan the Interfunction Delay bar code, then set the num-
ber of steps to 0. Scan the Save bar code using the
the back cover of this manual.
4 - 8
Prefix Scanned Data
STX 1 HT
Interfunction Delays
Interfunction Delay
Lower ASCII Reference Table
Character to Trigger Delay
Programming Chart
Programming Chart
Suffix
2 3 4 5 CR
Programming Chart
inside the
inside the
LF
inside