General Assembly Instructions - Vacmaster VK609PFR 0201 Operator's Manual

GENERAL ASSEMBLY INSTRUCTIONS

A Philips head screw driver is required.
1
6
11
16
WARNING:
SURE THE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY SHAMPOO
VACUUM. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
UNPACKING YOUR WET/DRY SHAMPOO VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the latches (Fig. 2).
3. Lift the power head off the collection tank (Fig. 3).
4. Remove the contents from inside the collection tank; make sure you have all contents as listed
on page 8.
5. Turn the collection tank upside down and insert the two front caster feet into the slots on the
collection tank and tighten with supplied screws. Verify that the casters are mounted correctly.
Do not over-tighten screws (Fig. 4).
6. Insert the two rear casters into the slots and apply pressure until they click into place (Fig. 5).
7. Insert the handle into the slots located on the top of the power head and secure it with the
screws provided. Do not over-tighten the screws (Fig. 6).
8. Your vacuum comes ready for dry vacuum cleaning. If the cartridge filter is not installed, refer to
page 19 for installation instructions (Fig. 7 & 8).
2
8
7
12 13
17 18
①
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE
3 4
9
14
19
10
5
10
15