Advertisement
Quick Links
Advertisement
Related Manuals for Vacmaster VK1638SWC
Summary of Contents for Vacmaster VK1638SWC
- Page 1 WET & DRY VACUUM CLEANER VK1638SWC IPX4 VK1638SWC / 1600W / 38L...
- Page 2 When To Change Filters Troubleshooting Thank you for purchasing this Vacmaster® vacuum cleaner. With Vacmaster® you are obtaining a high quality product that is engineered for optimal performance. This vacuum cleaner is capable of picking up dry materials as well as liquids.
-
Page 3: Important Safety Instructions
ARRANTY • Use insulating gloves, an earth connector connected to the steel container, or Vacmaster® takes pride in producing a high quality, durable product. This any other protective equipment when using the vacuum cleaner in some special Vacmaster® product carries a limited two (2) year warranty against defects places such as carpet or insulated floor. - Page 4 • When using for HEPA EPA RRP cleanup tasks, use only certified Vacmaster HEPA filter. NPACKING AND CHECKING CARTON CONTENTS • Even when used with a HEPA filter, extremely small particles may pass through the filter, always wear appropriate protective safety equipment.
- Page 5 ENERAL ASSEMBLY INSTRUCTIONS A Philips head screw driver is required. Push Handle Hose Hook / Power Cable Hook Exhaust Filter Handle On / Off Switch Handle Release / Power Cable Hook Latch WARNING: DO NOT PLUG IN POWER CORD TO POWER SOCKET, MAKE Vacuum Port SURE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET AND DRY Accessory Storage...
- Page 6 This vacuum cleaner can be used for lead renovation work under the US EPA 9. Fit collection bag flange onto the inlet stub, taking care not to damage Lead Renovation Repair and Painting rule. It can be used to pick up the bag.
- Page 7 LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE, ALCOHOL OR WARNING: IF FILTERS ARE CONTAMINATED OR HAVE BEEN USED, THEY MUST AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO; BE DISPOSED OF PROPERLY, PRIOR TO PERFORMING WET VACUUMING OPERATIONS. COAL, MAGNESIUM, GRAIN OR GUN POWDER.
- Page 8 1. Verify that the power cord is disconnected from the power socket. Verify that the tank is clean and free of dust and dirt. (fig. 1) IQUID VACUUM OPERATION 2. Remove all filters and dispose of properly. 3. Rinse out the inside of tank to remove any loose debris and dispose of liquid in suitable container.
- Page 9 AINTENANCE Installing HEPA Filter And Pre-filter 1. Verify that the power cord is disconnected from the power socket. (fig. 1) 2. Remove power head and place in an upside down position. 3. Install the HEPA filter over the filter cage with the flat end of the filter towards the vacuum cleaner power head.
-
Page 10: Troubleshooting
Change the pre-filter The pre-filter should be replaced with every fifth change of collection bag and whenever NSTALLING & CLEANING FOAM SLEEVE FILTER there is damage or a visible collection of debris on the outside of the filter. Change the HEPA filter Replace the HEPA filter when loss of vacuum continues to occur after you have checked for an obstructions in the hose or wand. - Page 11 DUST BAGS, FILTERS & ACCESSORIES always available from : cleva-uk.com VK1638SWC...