Vacmaster VK609PFR 0201 Operator's Manual page 16

CAUTION: BEFORE YOU USE THIS PRODUCT TO SHAMPOO CLEAN AN AREA,
TEST YOUR WET/DRY SHAMPOO VACUUM AND THE CLEANING SOLUTION ON A SMALL
HIDDEN AREA FOR COLORFASTNESS. IF THE COLOR IS AFFECTED, DO NOT USE.
CAUTION: THE CLEANING SOLUTION CONTAINS A CHEMICAL SOLUTION. AVOID
PROLONGED CONTACT AS SOME INDIVIDUALS MAY EXPERIENCE SKIN AND EYE
IRRITATION. FOR SKIN AND EYE IRRITATION, WASH AFFECTED AREA WITH WATER FOR
5-10 MINUTES. IF IRRITATION PERSISTS, SEEK MEDICAL ATTENTION IMMEDIATELY.
INDIVIDUALS WITH SENSITIVE SKIN SHOULD WEAR RUBBER GLOVES. WASH HANDS
THOROUGHLY AFTER USE. DO NOT INGEST. KEEP OUT OF REACH OF CHILDREN. USER
ASSUMES ALL RISK.
NOTE: ALWAYS DRY VACUUM THE AREA BEING CLEANED BEFORE USING THE
SHAMPOO MODE.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. To prepare your vacuum cleaner for carpet/upholstery cleaning, remove the cartridge filter.
3. Carefully install the supplied foam wet filter over the filter cage, making sure the filter cage is
completely covered. For foam wet filter installation instructions, see page 20 (Fig. 2).
4. Remove the cleaning solution tank from the vacuum base. Open the cap of cleaning solution
tank and pour the cleaning solution mixture into the tank. To make the cleaning solution mixture,
mix 1.5 oz. of cleaning solution per 0.5 gallon of water (Fig. 3).
NOTE: A 17 oz. (500ml) bottle of cleaning solution is provided with this vacuum cleaner. Ensure
the cleaning solution and water are mixed at the correct ratio. Water must be at room temperature.
NOTE: Once depleted, the cleaning solution can be replaced by a high-quality liquid carpet
cleaning solution that can be purchased from a local retailer. Always use the cleaning solution as
directed by the manufacturer.
5. Snap the cap of cleaning solution tank back into place. Then insert the cleaning solution tank
back into the vacuum base. Insert the end of the cleaning solution tube into the cleaning solution
tank (Fig. 4).
6. Insert the locking end of the hose into the vacuum port on the collection tank and turn clockwise
to lock into place. Connect the threaded connector on the end of the cleaning solution delivery
tube onto the cleaning solution outlet coupling (Fig. 5).
7. Insert the remote-control handle and its cleaning solution outlet coupling ( ② ) into the larger
end of the extension wand and its cleaning solution inlet connector ( ③ ) ensuring a "click" is
heard. The air flow regulation on the remote-control handle allows you to manually change the
amount of vacuum suction (Fig. 6 & 7).
8. Attach the carpet shampoo nozzle to the extension wand and make sure it clicks into place (Fig.
8 & 9).
For best performance, it is recommended to remove the brush holder during carpet cleaning.
Follow steps in Fig. 10. to remove the brush holder.
To re-install the brush holder, make sure to first align the arrows on the brush holder and the
nozzle as shown. Then move the brush holder to the left as indicated by the arrow until you hear a
"click" (Fig. 11).
CAUTION: NEVER PRY OR ROTATE THE SPRAY OUTLETS OF THE CARPET
SHAMPOO NOZZLE AND HANDHELD SHAMPOO NOZZLE WITH A SCREWDRIVER OR ANY
OTHER TOOL (FIG. 12 & 13).
16