Vacmaster VK609PFR 0201 Operator's Manual page 17

9. To clean sofas, chairs, stairs, and car interiors, connect the handheld shampoo nozzle onto the
remote-control handle (Fig. 14).
NOTE: When cleaning the headliner of your car, rotate the air flow regulation counter-clockwise to
decrease the suction power if the suction power is high.
NOTE: If there is dirt or debris accumulated in the handheld shampoo nozzle, press the release
button and remove the cover from the nozzle for cleaning (Fig. 15).
10.Plug the power cord into a power outlet (Fig. 16).
11.Turn on the motor by flipping the switch to the "I" ON position and the machine is ready for
use. Press the detergent mode button, indicated by the following symbol
remote-control handle or the power head for cleaning solution application only. Select both the
detergent mode and vacuum mode for simultaneous shampoo and wet vacuum operation (Fig.
17).
WARNING: THE MOTOR NOISE CHANGES TO A HIGHER PITCH WHEN THE
COLLECTION TANK IS FULL OR BLOCKED. STOP THE VACUUM IMMEDIATELY AND EMPTY
THE COLLECTION TANK.
12.Once you have completed cleaning, switch off the vacuum by pressing detergent mode button
on either the remote-control handle or the power head. Flip the switch to the "O" OFF position,
unplug the power cord from the power outlet and drain the liquid (Fig. 18).
O = OFF I = ON
NOTE: VACUUM THE CARPET/UPHOLSTERY THOROUGHLY BEFORE USING THE
SHAMPOO MODE.
• For carpet cleaning it is recommended to remove all furniture from the room to be cleaned or
move it away from the cleaning area. Clean the whole carpet systematically in squares, using
strokes of approximately 5ft. (1.5m) each. This avoids walking over the cleaned carpet until it is
completely dry.
• Start furthest away from the entrance of the room, extend the hose, and work backwards.
• Pull the carpet shampoo nozzle back towards you in approximately 5ft. strokes. Refill the
cleaning solution tank if the solution runs out.
• Select the vacuum mode, indicated by the following symbol
More cleaning solution can be applied to heavily soiled areas. The dirty liquid is visible as it is
sucked up through the carpet shampoo nozzle. Stop vacuuming when the liquid being extracted
is no longer dirty.
• Do not walk over or place furniture on the cleaned area until it is completely dry.
• The handheld shampoo nozzle is ideal for cleaning sofas, chairs, stairs and car interiors.
• The carpet shampoo nozzle is ideal for cleaning carpets.
DISASSEMBLING THE WET/DRY SHAMPOO VAC
NOTE: SOME LIQUID MAY REMAIN IN THE TUBES AFTER USING THE PRODUCT FOR
LIQUID OR SHAMPOO CLEANING. DISASSEMBLE THE VACUUM OUTDOORS OR OVER A
SINK AS THERE MAY BE SOME LEAKAGE.
To disassemble the shampoo vacuum, follow the steps below.
1. Remove the cleaning solution tube from the power head by pressing down on the yellow latch.
Disconnect the hose from the vacuum.
2. Disconnect the accessories and/or extension wand from the remote-control handle by pressing
down on the release button (Fig. 19).
= DETERGENT MODE
, to suck up the dirty solution.
17
, on either the