Table of Contents
Advertisement
To replace the glass panels,
do the same steps in
reverse. Before you lower
the trim, attach the A trim
part to the door. Refer to the
image.
12.7 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven. Wait until the oven
is cold.
2. Disconnect the oven from the mains.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem
You cannot activate the ap‐
pliance.
You cannot activate the ap‐
pliance.
You cannot activate or oper‐
ate the hob.
You cannot activate or oper‐
ate the hob.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
Residual heat indicator does
not come on.
Automatic Heat Up function
does not operate.
3. Put a cloth on the bottom of the
cavity.
The back lamp
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a
suitable 300 °C heat-resistant oven
lamp.
Use the same oven lamp type.
4. Install the glass cover.
Possible cause
The appliance is not connec‐
ted to an electrical supply or
it is connected incorrectly.
The fuse is blown.
You touched 2 or more sen‐
sor fields at the same time.
There is water or fat stains
on the control panel.
You put something on one or
more sensor fields.
The zone is not hot because
it operated only for a short
time.
The zone is hot.
The lamp glass cover is at
the back of the cavity.
Remedy
Check if the appliance is cor‐
rectly connected to the elec‐
trical supply.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali‐
fied electrician.
Touch only one sensor field.
Clean the control panel.
Remove the object from the
sensor fields.
If the zone operated suffi‐
ciently long to be hot, speak
to an Authorised Service
Centre.
Let the zone become suffi‐
ciently cool.
ENGLISH
35
Advertisement
Table of Contents
