Table of Contents
Advertisement
To replace the glass panels,
do the same steps in
reverse. Before you lower
the trim, attach the A trim
part to the door. Refer to the
image.
12.6 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven. Wait until the oven
is cold.
2. Disconnect the oven from the mains.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem
You cannot activate the ap‐
pliance.
You cannot activate the ap‐
pliance.
The burners do not work.
There is no spark when you
try to activate the spark gen‐
erator.
The flame extinguishes im‐
mediately after ignition.
The flame ring is uneven.
The oven does not heat up.
The oven does not heat up.
3. Put a cloth on the bottom of the
cavity.
The back lamp
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a
suitable 300 °C heat-resistant oven
lamp.
Use the same oven lamp type.
4. Install the glass cover.
Possible cause
The appliance is not connec‐
ted to an electrical supply or
it is connected incorrectly.
The fuse is blown.
There is no gas supply.
Burner cap and crown are
placed incorrectly.
Thermocouple is not heated
up sufficiently.
Burner crown is blocked with
food residues.
The oven is deactivated.
The clock is not set.
The lamp glass cover is at
the back of the cavity.
Remedy
Check if the appliance is cor‐
rectly connected to the elec‐
trical supply.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali‐
fied electrician.
Check the gas connection.
Place the burner cap and
crown correctly.
After lightning the flame,
keep the knob pushed for
equal or less than 10 sec‐
onds.
Make sure that the injector is
not blocked and the burner
crown is clean.
Activate the oven.
Set the clock.
ENGLISH
29
Advertisement
Table of Contents
