Table of Contents
Advertisement
●
Select <Off>. If you select <DHCP> when these services are unavailable, the machine will waste time
and communications resources searching the network for these services.
3
Check that <Auto IP> is set to <On>.
●
If <Off> is selected, change the setting to <On>.
4
Select <Apply>.
●
IP addresses assigned via DHCP override the address obtained via Auto IP.
Manually entering an IP address
1
Configure a setting to disable auto-acquisition.
●
Select <Auto Acquire>, and set both <Select Protocol> and <Auto IP> to <Off>.
2
Select <Manually Acquire>.
3
Specify the IP address, subnet mask, and gateway address (or default gateway).
●
Enter these values in each screen, and select <Apply>.
●
On how to enter text, see
Checking whether the settings are correct
●
Make sure that the Remote UI screen can be displayed with your computer (
UI(P. 178) ). If a computer is not available, you can check the connection by using the operation panel (
Testing the Network Connection(P. 40) ).
When you have changed the IP address after installing the printer driver
●
When the MFNP port is used, the connection is maintained as long as the machine and the computer belong
to the same subnet; therefore, you do not need to add a new port. When the standard TCP/IP port is used,
you need to add a new port.
*
If you do not know which port is used, see
Testing the Network Connection
1
Select <Menu> in the Home screen.
2
Select <Network Settings>.
●
If the screen for entering a PIN appears, enter the correct PIN.
3
Select <TCP/IP Settings>
4
Enter the IPv4 address of another device on the network, and select <Apply>.
➠
If a proper connection has been established, <Received response from host.> is displayed.
Setting Up
Entering Text(P. 94) .
Configuring Printer Ports(P. 50)
Checking the Printer Port(P. 337) .
Home Screen(P. 88)
<IPv4 Settings>
40
Starting Remote
Setting the System Manager PIN(P. 145)
<PING Command>.
Advertisement
Table of Contents
