Table of Contents
Advertisement
The screwdriver starts as soon as connected to the air supply.
Please make sure that the flow rate of the remote valve is
minimum 0.2 m³/min.
5
Disassembly - Assembly
Disassembly: (see Spare Parts Drawing)
CAUTION
Prior to disassembly, disconnect equipment from air
supply in order to avoid the unintentional start of the
tool which may result in hand injuries!
Only experienced maintenance personnel may
assemble or disassemble this equipment.
After repair or maintenance, verify that equipment runs to specification!
Principally, use only DEPRAG original spare parts. Otherwise, a reduction
in equipment power-output and an increased maintenance-requirement
occurs. If NON-DEPRAG parts are installed, DEPRAG is justified to void
any existing warranty and liability obligations.
ATTENTION
Never clamp motor housing into a vice, without the usage of the
protective chucking jaws, since damage to motor-housing and
internal parts is unavoidable.
ATTENTION
Motor- and gearing parts may be damaged if dropped!
For disassembly proceed in the sequence described below:
1.
Disconnect driver from air supply.
2.
Unscrew spring sleeve 364670 A (Accessories - Optional Equipment)
(left-hand thread).
3.
Unscrew clutch bearing 335691 (AF 14, left-hand thread).
4.
Take out clutch 337310 C / 347227 C complete.
5.
Unscrew slide connector 821431 (AF 8, right-hand thread) and remove
guide bolt 328493.
6.
Clamp motor housing by means of the chucking jaws 461500 into a vice.
16
Advertisement
Table of Contents
