How To Configure A Periodic Reset Timer - NetComm NTC-5000 Series User Manual

NetComm Commercial
Periodic Ping Disabled
To disable the Periodic Ping Reset Monitor simply set to "Fail Count" 0.
Periodic Ping Enabled
An Example Setup:
The setup below will ping 10.1.2.3 every 10 minutes, if it fails it then tries to ping 10.1.2.4, if that also fails it then accelerates the ping
attempts to once every 60 seconds and if 3 successive ping attempts at the one minute interval fails, the router will reboot.
NOTE: The traffic generated by the periodic ping feature is counted as chargeable usage, please keep this in mind when selecting how often to ping.

7.4 How to configure a Periodic Reset Timer

This facility is available by clicking on the "Services" menu followed by the "System Monitor" menu item on the right..
The router can be configured to automatically reboot after a periodic interval specified in minutes. While this is not necessary, it does ensure
that in the case of remote installations, it will reboot the router if some anomaly occurs.
The default value is 0 which disables the Periodic Reset Timer. The maximum value is 65535 minutes.
NTC-5000 Series User Guide
28
YML5000
www.netcomm.com.au