To Remove A Pc Card - HP OmniBook 800 Installation And Setup Manual

C A U T I O N
Expanding the OmniBook
Connecting External Devices

To remove a PC card

Do not remove a disk while it is actively reading or writing. If you remove a
disk while it is active, its data could become corrupted.
Do not remove an I/O card while an application is open that is set up to use
that card. Exit the application first. Otherwise, the application or the computer
might behave unpredictably or stop responding until you restart the
OmniBook.
1. If you are using Windows 95, stop the PC card before ejecting it: Click the PC
Card indicator in the taskbar, then click the Stop command for the PC card. (To
restart a card, remove it, then insert it again.)
2. For a card in the upper card slot, slide the card-eject lever toward the end of the
case until the card pops out, then pull out the card.
—or—
For a card in the lower card slot, turn over the OmniBook, release the two
latches on the bottom of the slot tray, and pull out the tray.
3-14