HP OmniBook 800 Installation And Setup Manual page 68

Troubleshooting
Solving Basic Problems
If the OmniBook doesn't reboot successfully (Windows 95)
If your operating system is Windows 95
If no text is displayed during reboot, or if the system stops before you see
"Starting Windows 95...", the unit might require service. Try rebooting again.
You can try to start the System Configuration Utility (press F2 during reboot),
then select Factory Default Settings from the Defaults menu, and then select
Save from the Exit menu.
If you see "Starting Windows 95..." during startup followed by error messages,
reboot again—but when you see "Starting Windows 95...", press
startup menu. Choose a startup option that might help you discover or fix the
problem.
Use the "safe mode" option to start Windows with a basic configuration.
Run ScanDisk (in Start, Programs, Accessories, System Tools) to fix
problems with drive C. You can also make other changes to repair your
startup files.
Use the "step-by-step" option to step through each startup command to find
where problems occur, so you can repair or restore any files indicated.
If drive C (the hard disk) isn't working properly, insert the Support Utility floppy
disk in the floppy drive, then press
choose the Minimum Startup option. (Note that the System Configuration Utility
must have System, Boot Devices set to boot FDD First.) At the MS-DOS prompt,
type scandisk c: to fix certain problems with drive C. You can use other
commands on drive A to try to repair drive C. Then remove the floppy disk and
try rebooting again. If it still doesn't start, you could try reinstalling all of the
original files on drive C—see "Reinstalling Windows" in chapter 2.
5-4
to reboot from drive A—then
CTRL+ALT+DEL
to get the
F8