HP OmniBook 800 Installation And Setup Manual page 38

Expanding the OmniBook
Replacing Internal Hardware
3. Close the cover and turn your computer over. Using a Torx-T6 screwdriver,
remove the five screws holding the hard drive and the keyboard in place (the
exact locations vary with the type of hard drive).
4. Turn the computer back over. Remove the keyboard by inserting your fingertips
between the top row of keys (the F keys) and the case and then lifting. Then
fold the keyboard gently forward so that it lies upside down on the table. Do not
pull up on the keyboard. Keep the ribbon cables tucked in the case, otherwise
you will need to tuck them back in with a paper clip. Do not pick up the computer
while the keyboard is out.
3-4
Ribbon cables