HP OmniBook 800 Installation And Setup Manual page 32

Reinstalling Windows
Reinstalling Windows for Workgroups
3. Connect a SCSI CD-ROM drive (HP part number F1196A) to the OmniBook's
docking/SCSI port according to the CD-ROM drive's instructions. (This requires
a special OmniBook-to-SCSI adapter cable, HP part number F1182A, unless you
are using a docking system.) If you have a non-SCSI CD-ROM drive (parallel
port or PC-card slot), read the README.1ST file on the Support Utilities disk.)
4. Turn on the CD-ROM drive and insert the Recovery CD-ROM —make sure you
use the correct CD-ROM.
5. Insert the Support Utilities disk into the floppy drive.
6. Exit Windows, if necessary, then reboot the OmniBook from the Support Utilities
disk by pressing the reset button. (To restart from the floppy drive, the System
Configuration Utility must have System, Boot Devices set to FDD First.)
7. Select the option Install Windows for Workgroups Drivers and HP Applications
Software, which loads the special drivers you need with the OmniBook. It also
loads OmniBook-specific software: the online User's Guide, the Appointment
Book, the Phone Book, the HP Calculator, OmniBook diagnostics, OmniBook
Tools, and the icon-print routine for shortcut key assignments.
8. Select the WfW Install option appropriate for your CD-ROM drive: SCSI port or
PC-card slot/parallel port.
This re-installation process can take an hour or more. When the above installation is
done, you can use Windows to add printers and enable networks.
2-6